Rainier AWD V8-5.3L VIN P (2004)
11. Loosen the bolts.
12. Separate the dies.
Important: If deformities exist in the swage clamp, place the swage clamp back into J 41048. Ensure the swage clamp covers the whole swaging
area. Re-swage the swage clamp.
13. Inspect the swage clamp for any "lip" deformities.
Important: Assemble the joint with the convolute retainer in the correct position. Assemble the joint to meet the specified dimension to avoid boot
damage.
14. Install the convolute retainer over the boot capturing four convolutions.
Important: Ensure that the rings are fully seated.
15. Install the spacer ring (2) and spider assembly (1) onto the halfshaft bar (3).
16. Install the other spacer ring in the groove at the end of the halfshaft bar. Ensure that the rings are fully seated.
17. Pack the boot and housing with the grease supplied in the kit. The amount of grease supplied in this kit has been pre-measured for this application.
