Rainier AWD V8-5.3L VIN P (2004)
Wiper Motor: Service and Repair
Wiper Motor Replacement - Rear
WIPER MOTOR REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the wiper arm.
2. Remove the nut and spacer from the wiper motor shaft.
3. Remove the interior trim panel from the liftgate.
4. Disconnect the wiper motor electrical connector.
5. Remove the 2 bolts retaining the wiper motor to the liftgate.
6. Remove the wiper motor.
INSTALLATION PROCEDURE
1. Install the wiper motor.
2. Install the 2 bolts retaining the motor to the liftgate.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 8 N.m (71 lb in).
3. Connect the wiper motor electrical connector.
4. Install the interior trim panel to the liftgate.
5. Install the spacer and the nut on the wiper motor drive shaft.
Tighten the nut to 8 N.m (71 lb in).
6. Install the wiper arm.
