Reatta V6-231 3.8L VIN C SFI (1990)
Keyless Entry Transmitter: Service and Repair
Convertible
RKE Receiver Module
Before starting this procedure, BOTH transmitters must be present. Failure to use both transmitters will render the missing transmitter inoperative. (If the
customer uses only one transmitter on the vehicle, use this transmitter as transmitter 1 and 2 This is not the normal situation.)
The entire reprogramming sequence must be completed within 30 seconds of grounding the reprogramming conne9tor (Step # 2 below). If the procedure
is not completed, remove the ground at the connector and restart the procedure from step (1) one.
1. Ignition "ON"
2. (Reatta Convertible) Ground single wire connector located at the left tonneau cover hinge on the tonneau body main connector.
3. Wait for door locks to lock and unlock (Should take two seconds).
4. Press the "Unlock" button on the first transmitter twice (Pause for one second between presses).
5. Wait for door locks to lock and unlock (Should take two seconds).
6. Press the "Unlock" button on the second transmitter twice (Pause for one second between presses).
7. Wait for door locks to lock and unlock (Should take two seconds).
8. Remove ground from green connector.
After programming sequence is done verify proper operation of all functions on both transmitters.
