Reatta V6-231 3.8L VIN C SFI (1990)
Convertible Top Frame: Customer Interest
Convertible Rear Roof Pins - Popping Loose
Bulletin 90-10-28
Date July '90
Ref. No. 90-143-10
Corp. Ref. No. 011512
SUBJECT:
REAR ROOF PIN ALIGNMENT AND LOCK LATCH CABLE ADJUSTMENTS (TIGHTEN TOP STACK REAR ROOF PINS)
MODELS AFFECTED: 1990 REATTA CONVERTIBLE
FIGURE 1
Some Reatta convertibles may experience a condition of the top stack rear roof pins popping loose from the stowage panel. To repair this condition
perform the following adjustments:
Open the driver door, open the stowage compartment door behind driver seat, operate the rear roof pin release handle by pulling forward and up until
pins release. If the rear roof pins do not release, the stowage panel pin latches can be accessed through the rear compartment by pulling forward on the
latch spring, each side must be operated separately. Refer to Figure 1.
