Reatta V6-231 3.8L VIN C SFI (1990)
Refer to 1990 Riviera and Reatta Service Manual Section 3F4
1.
Read precautions on handling SIR Inflator Module (pages 2 and 3).
2.
Disable the SIR system (page 2).
3.
Remove and install new Inflator Module (pages 4 and 5).
4.
Enable the SIR system (page 3).
5.
Retain removed Inflator Module properly tagged in Inflator Module shipping container until further notice. ***CAUTION: DO NOT
DEPLOY***
6.
Install Campaign Label for 90-C-9.
Warranty Information
Claims for Product Campaign 90-C-9 may be submitted immediately.
Sublet
Failure
Labor
Labor
Other
Dealer
Oper.
Code
Op. No.
Hours
Hours
Mtl. Twg.
Replace SIR Inflator Module
96
V6640
.5
*0.1
**113.40
*
0.1 hour for administration
** $113.40 represents 30% of current dealer price of furnished parts.
A Product Campaign Bulletin 90-C-9 will be sent later.
Dear Buick Owner:
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.
Reason For This Recall
General Motors has determined that a defect which relates to motor vehicle safety exists in some 1990 Buick Riviera and Reatta model vehicles. In the
event of an accident requiring deployment of the driver's side Supplemental Inflatable Restraint (SIR), the SIR Inflator Module located in the steering
wheel assembly, could separate. if separation occurs, the air bag will not inflate as intended, and the driver will not be properly restrained. In addition,
separation of the SIR Inflator Module may result in hot combustion gases escaping into the occupant compartment, presenting the possibility that vehicle
occupants could receive burn injuries. What We Will Do
To correct this condition, your dealer will replace the SIR Inflator Module. This service will be performed for you at no charge.
What You Should Do
Please contact your Buick dealer as soon as possible to arrange a service date. Instructions for making this correction have been sent to your dealer and
parts are available. (Your zone/branch has been instructed to try to contact you as soon as parts are received by the dealer.) The labor time necessary to
perform their service correction is approximately 30 minutes. Please ask your dealer if you wish to know how much additional time will be needed to
schedule and process your vehicle.
Your Buick dealer is best equipped to obtain parts and provide service to ensure that your vehicle is corrected as promptly as possible. If however, you
take your vehicle to your dealer on the agreed service date, and they do not remedy this condition on that date or within five (5) days, we recommend you
contact the Buick Customer Assistance Center, Flint Home Office, by calling 1-800-521-7300.
After contacting your dealer and the Customer Assistance Center, if you are still not satisfied that we have done our best to remedy this condition without
charge and within a reasonable time, you may wish to write the Administrator, National Highway Traffic Safety Administration, 400 Seventh Street, S.
W., Washington, DC 20590 or call 1-800-424-9393 (Washington, DC residents use 366-0123).
The enclosed owner reply card identifies your vehicle. Presentation of this card to your dealer will assist in making the necessary correction in the
shortest possible time. If you have sold or traded your vehicle, please let us know by completing the postage paid reply card and returning it to us.
We are sorry to cause you this inconvenience; however, we have taken this action in the interest of your safety and continued satisfaction with our
