Regal L4-2.0L Turbo (2011)
Key: Technical Service Bulletins
Interior/Locks - Key Cutting Procedure
INFORMATION
Bulletin No.: 09-00-89-029F
Date: January 05, 2011
Subject: Key Cutting Procedure for Obtaining Replacement Key
Models:
2010-2011 Buick LaCrosse
2011 Buick Regal
2010-2011 Chevrolet Camaro, Equinox
2011 Chevrolet Cruze, Volt
2010-2011 GMC Terrain
2008-2009 Pontiac G8
Attention:
This bulletin applies to the United States and Canada only. Export dealers are to contact their local Technical Assistance Center (TAC) for further
information.
Supercede:
This bulletin is being revised to add the Chevrolet Volt. Please discard Corporate Bulletin Number 09-00-89-029E (Section 00 - General Information).
Due to the uniqueness of the ignition/door lock key, special equipment is required to cut a key. If you do not have the required equipment, you may order
a cut/coded key through GM CC&A.
To obtain a replacement key, the following procedure is suggested:
1. Obtain the vehicle key code.
U.S. Dealers: Access the "Key Code Look Up" application through GM GlobalConnect under the Parts Workbench.
Canadian Dealers: Access the "KeyCode Look-Up" feature within the OEConnection D2DLink application.
2. Submit a part order through the GM CC&A Parts System for a key blank. Be sure to include the key code in the "note" field of the order.
3. DO NOT ORDER AN UNCODED KEY AS YOU WILL RECEIVE A BLANK KEY THAT WILL REQUIRE CODING ON THE
SPECIAL EQUIPMENT LISTED BELOW.
Note
The key code is five digits. Some vehicle records do not have the first digit displayed (i.e., vehicle records show the key code as "1234"). When ordering
a cut/coded key, refer to the key code table.
Important
The order will be shipped the same day if received by 12:00 p.m. (noon) EST, or within 24 hours, Monday through Friday via FedEx (Canadian
dealers should place their orders for these parts using a CSO order type only. Do not order using the CSO3 order type).
Important
The remote control transmitter and the key shank are not serviced separately.
Important
