Regal L4-2.0L Turbo (2011)
10. Install the master cylinder primary brake pipe fitting (1) and tighten to 18 Nm (13 lb ft).
11. Install the master cylinder secondary brake pipe fitting (2) and tighten to 18 Nm (13 lb ft).
12. Connect the EBCM electrical connector.
13. Install the radiator surge tank. Refer to Radiator Surge Tank Replacement (See: Engine, Cooling and Exhaust/Cooling System/Coolant
Reservoir/Service and Repair/Radiator Surge Tank Replacement).
14. Connect the brake fluid level sensor electrical connector.
15. Install the battery tray. Refer to Battery Tray Replacement (See: Starting and Charging/Battery/Battery Tray/Service and Repair).
16. Program the EBCM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
17. Bleed the antilock brake system. Refer to Antilock Brake System Automated Bleed (See: Brake Bleeding/Service and Repair/Antilock Brake
System Automated Bleed).
18. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).
19. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration (See: Accessories and Optional Equipment/Pedal
Positioning System/Pedal Positioning Sensor/Service and Repair/Brake Pedal Position Sensor Calibration).
20. Center the steering angle sensor. Refer to Steering Angle Sensor Centering (See: Sensors and Switches/Sensors and Switches - Steering and
Suspension/Sensors and Switches - Steering/Steering Angle Sensor/Service and Repair/Procedures).
