Regal L4-2.0L Turbo (2011)
Camshaft: Service and Repair
Camshaft Position Intake Actuator Replacement
Camshaft Position Intake Actuator Replacement
Special Tools
*
EN-48749 Timing Chain Retention Tool Kit
*
EN-48953 Camshaft Actuator Locking Tool
*
EN-45059 - Angle Meter
Removal Procedure
1. Remove the camshaft cover. Refer to Camshaft Cover Replacement (See: Cylinder Head Assembly/Valve Cover/Service and Repair).
2. Remove the spark plugs. Refer to Spark Plug Replacement (See: Tune-up and Engine Performance Checks/Spark Plug/Service and Repair).
3. Rotate the crankshaft clockwise and install the camshaft actuator retainer EN-48953 (1).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the camshaft actuator retainer bolts and tighten to 10 Nm (89 lb in) .
5. Loosen, but DO NOT remove the intake camshaft actuator bolt.
6. Remove the camshaft actuator locking tool, EN-48953 (1).
7. Clean the timing chain and gears with solvent.
Note: Ensure the timing chain and the camshaft position actuators are marked for proper assembly.
8. Mark the intake and exhaust camshaft actuators and the respective locations on the timing chain.