Regal L4-2.0L Turbo (2011)
3. Ensure that the terminal release tang access panel is in the correct location to access the terminals.
4. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
5. Insert the J-38125-11A into the terminal release tang access slot located behind the access panel of the connector and press down on the terminal
while carefully pulling the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the
terminal is difficult to remove, repeat the entire procedure.
6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) (See: Repairing Connector Terminals
(Terminated Lead Repair))Repairing Connector Terminals (Terminal Repair) (See: Repairing Connector Terminals (Terminal Repair))
procedure.
7. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
