Regal L4-2.0L Turbo (2011)
Note: Be careful not to angle or rock the J-38125-21 tool when inserting it into the connector or the tool may break.
6. Insert the J-38125-21 tool into the round canal between the terminals cavities at the front of the connector.
7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a
terminal out of a connector.
8. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) (See: Repairing Connector Terminals
(Terminated Lead Repair))Repairing Connector Terminals (Terminal Repair) (See: Repairing Connector Terminals (Terminal Repair))
procedure.
9. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
