Regal L4-2.0L Turbo (2011)
Auxiliary Power Outlet: Diagnostic Aids
Tyco/AMP Connectors (43-Way)
Tyco/AMP Connectors (43-Way)
Special Tools
*
EL-38125-580 - Terminal Release Tool Kit
*
J-38125-12A - Terminal Release Tool
*
J-38125-13A - Terminal Release Tool
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Terminal Removal Procedure
Follow the steps below in order to remove terminals from the connector.
1. Locate the lever lock on the wire dress cover. Slide the lever lock away from the connector body.
2. Disconnect the connector from the component.
3. Locate the dress cover locking tabs on the dress cover of the connector. Using a small flat-blade tool release all of the locking tabs.
4. Once the locks are unlocked, lift the dress cover off.
Note: Always use care when removing a terminal position assurance (TPA) in order to avoid damaging it.
5. Release the TPA by inserting a small flat-blade tool into the blue locking tabs on both ends of the connector. Gently slide the TPA up to the
released position on both ends.
