Regal L4-2.0L Turbo (2011)
3. Install the nub of the DT-41239-1A - Cooler Line Seal Installer on the transaxle cooler line seal.
4. Tap the new transaxle cooler line seal into the case bore.
5. Install the transaxle oil cooler line assembly to the transaxle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
6. Install the transaxle oil cooler line assembly nut and tighten to 9 Nm (80 lb in).
7. Lower the vehicle.
Note: DEXRON(R) VI automatic transmission fluid is not compatible with this transaxle. If DEXRON(R) VI ATF is used, transaxle failure will
result. This transaxle uses GM AW-1 fluid P/N 19256039.
8. Add fluid to the transaxle. Refer to Adhesives, Fluids, Lubricants, and Sealers (See: Specifications/Sealant)
9. Start the engine and check for leaks.
