Regal L4-2.0L Turbo (2011)
4. Ensure that the TPA is in the proper position to remove the terminals.
5. While pushing the terminal forward, insert the J-38125-24 in the release cavity above the terminal you are removing, gently pull the wire out of the
back of the connector. Always remember never use force when pulling a terminal out of a connector.
6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) (See: Repairing Connector Terminals
(Terminated Lead Repair))Repairing Connector Terminals (Terminal Repair) (See: Repairing Connector Terminals (Terminal Repair))
procedure.
7. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.