Regal L4-2.0L Turbo (2011)
Turn transmission control lever knob (1) 180 degrees and install to transmission control lever.
Push the 2 pins (2) into the 2 holes (3).
Remove engine control module from battery tray and lay aside.
Block transmission control housing (2) using a 5 mm rod (1).
Installation Procedure
Note: When locking the adjuster locks (1) a defined snap noise should be audible, a snap effect should be felt.
Lock shift lever and selector lever cable adjust locks.
Lock shift lever and selector lever cable adjust locks (1), by pushing down the two blue locking pieces WITHOUT touching/preloading the fixed shift
lever.