Regal V6-173 2.8L (1988)
INSPECT
^ Check I.D. of bore for nicks or burrs and correct as required. Inspect crankshaft for burrs or nicks on surface which contacts seal. Repair or replace
crankshaft as required.
INSTALL OR CONNECT
1. Apply engine oil to I.D. and O.D. of new seal. Slide new seal over mandrel until back of seal bottoms squarely against collar of tool.
2. Seal
a. Align dowel pin of tool with dowel pin in crankshaft and attach tool to crankshaft by hand, or tighten attaching screws to 5 Nm (60 in. lb.).
b. Turn "T" handle of tool so that collar pushes seal into the bore, turn handle until the collar is tight against the case. This will ensure the seal is
seated properly.
c. Loosen the "T" handle of the tool until it comes to a stop. This will ensure that the collar will be in the proper position for installing another
new seal.
d. Remove attaching screws.
Inspect
^ Check seal, making sure seal is seated squarely in the bore.
3. Flywheel.
Tighten
^
Bolts to 61-75 Nm (45-55 ft. lb.)
4. Transaxle.
Tighten
^
Bolts to 65-85 Nm (48-63 ft. lb.)
5. Remove engine support.
INSPECT
^ Proper fluid levels.
^ Leaks.
^ Completion of repair.
