Regal V6-173 2.8L (1988)
-
Remove the R.H.hush panel, see Fig.3.
-
Remove the ash tray retainer, Fig. 4, and disconnect the wiring harness from the retainer.
-
Remove the adapter duct, see Fig. 1.
-
Remove the heater outlet duct, see Fig.1.
-
Remove the two top screws from the module, one on each side. These two screws will be used to mount the new heater outlet duct, see Fig. 2.
-
Install the 1/8 X 3/4 in. foam tape to the grooved mounting surface of the new heater outlet duct, approximately 11-3/4 in. across the top of the
outlet duct and 7 in. on each side. Trim off the excess tape.
-
Install the new heater outlet duct to the module, see Fig. 2.
-
Install the adapter duct, see Fig. 1.
-
Using a bench grinder, make a 2 in. long by 3/8 in. deep cutout in the front edge of the ash tray retainer, as shown in Fig. 4.
-
Install the wiring to the retainer and install the ash tray retainer.
-
Cut off a two inch square piece of the R.H. hush panel as indicated in Fig. 3.
-
Install the R.H. hush panel.
-
Make sure the ash retainer does not interfere with the new heater outlet duct.
WARRANTY INFORMATION
Labor Operation:
T1510
Labor Time
: 0.6
