Regal V6-173 2.8L (1988)
If codes match any of the combinations on list or are unreadable/illegible, the wheel must be replaced.
4.
Repeat above procedure for remaining three wheels on vehicle.
REPLACEMENT
5.
As required by inspection, replace necessary wheels (& balance). Use torque stick J39544-15 and impact gun to tighten lug nuts to appropriate
torque.
This should be done in two steps using the star pattern. First, sung the nuts down by hand. Then using the star pattern and a torque stick or torque
wrench, tighten the wheel nuts to about half the final torque. Finally, tighten the wheel nuts to specification using the star pattern and the torque
stick/wrench. Use the same amount of impact wrench operating time as would normally be used without a torque stick.
6.
Render all removed wheels unusable and scrap as required by Corporate Policy and Procedures.
7.
Install Campaign Identification Label.
