Regal V6-173 2.8L (1988)
Manifold Pressure/Vacuum Sensor: Testing and Inspection
Scan Tool Testing - Without Speed Density Update
INSPECTION
A "SCAN" displays manifold pressure in volts. Low pressure (high vacuum) reads a low voltage while a high pressure (low vacuum) reads a high
voltage A failure in the MAP sensor circuit should set a Code 63 or 64 and using the chart will find the cause of the problem. A Code 63 may be
set if a rough or unstable idle exists.
Chart C-1D can also be used to check Manifold Absolute Pressure (MAP) sensor. Refer to Computers and Controls / System Diagnosis /
Procedures / Diagnostic Charts / Chart C-1D. See: Testing and Inspection
