Regal V6-173 2.8L (1988)
Procedure:
(Reference Figure #1)
1.
Place vehicle in park. Set parking brake and disconnect negative battery cable.
2.
Disconnect throttle valve (T.V.), accelerator, and cruise control cables from the throttle body.
3.
Remove the circular "E" clip (Figure #I, Item #1) from the throttle actuating link stud of the throttle lever (Item #12).
4.
Using a T40 Torx Bit, rotate the throttle actuating lever screw (Item #3) CLOCKWISE to remove it from the throttle body.
CAUTION:
Keep fingers clear of throttle actuating lever. Springs are under tension and will unwind when tension is released. Springs may become detached and
cause injury. Wear safety glasses.
IMPORTANT:
