Regal V6-191 3.1L (1991)
32.
Disconnect lower ground strap at transaxle.
33.
Remove torque convertor bolts.
34.
Remove A/C compressor mounting bolts and securely reposition compressor.
35.
Remove transaxle support bracket bolts at transaxle.
36.
Remove front engine mount nuts at frame.
37.
Remove both lower bell housing bolts.
38.
Lower vehicle.
39.
Install engine lifting device.
40.
Remove remaining bell housing bolts.
41.
Install transaxle support.
42.
Remove engine.
43.
Remove flywheel.
44.
Install engine assembly on engine stand and remove lifting device.
45.
Remove generator mounting bracket and pencil brace.
46.
Remove intake plenum with throttle body attached.
47.
Remove ignition module assembly with spark plug wires attached.
48.
Remove throttle body heater pipe.
49.
Remove both rocker arm covers.
50.
Remove heater hose pipe at intake manifold and cylinder head.
51.
Remove intake manifold.
52.
Remove engine torque strut bracket.
53.
Remove both exhausts manifolds.
54.
Remove upper engine wiring harness.
55.
Remove serpentine belt tensioner.
56.
Remove crankshaft balancer mounting bolt and balancer, using tool J 24420-B.
57.
Remove front engine mount bracket.
58.
Remove Electronic Spark Control (ESC) knock and crank sensors.
59.
Remove engine block heater, if equipped.
60.
Remove oil filter adaptor.
61.
Remove fuel line bracket.
62.
Remove coolant temperature sensor.
63.
Remove transaxle support bracket.
64.
Remove water pump pulley.
