Regal V6-191 3.1L (1991)
Timing Cover: Service and Repair
Front Cover Replace
Figure 2 Front Cover Assembly
REMOVAL
1. Disconnect negative battery cable then drain coolant.
2. Drain and recover the cooling system then remove coolant reservoir.
3. Remove drive belt tensioner.
4. Remove generator.
5. Remove power steering pump and support aside.
6. Raise vehicle and suitably support.
7. Remove inner splash shield.
8. Remove flywheel cover at transaxle.
9. Remove starter.
10. Remove crankshaft balancer.
11. Remove serpentine belt idler pulley.
12. Remove oil pan.
13. Remove lower cover bolts then lower vehicle.
14. Remove radiator hose at coolant pump.
15. Remove heater coolant hose at cooling system fillpipe.
16. Remove bypass and overflow hoses.
17. Remove EVAP canister purge hose.
18. Remove upper front cover bolts then front cover.
CLEAN
^
Mating surfaces of the front cover and cylinder block.
^
Sealing surfaces with degreaser.
INSTALLATION
1. Install new front cover gasket.
CAUTION Make sure not to damage sealing surfaces.
2. Apply sealer GM P/N 1052917 (or equivalent) to sealing surfaces of front cover.
3. Install new seal.
4. Install front cover on the engine and install upper cover bolts and torque # 5 bolts to 27-48 Nm (20-35 lb. ft.). and # 4 bolts to 18-36 Nm (13-26
lb. ft.). Refer to figure 2
5. Raise vehicle.
6. Install oil pan.
^
Tighten Oil Pan Bolt to 8 Nm (71 lb. in.)
^
Tighten Oil Pan Nut to 8 Nm (71 lb. in.)
^
Tighten Oil Pan Rear Bolts to 25 Nm (18 lb. ft.)
^
Tighten Oil Pan Stud to Cylinder Block to 8 Nm (71 lb. in.)
7. Install lower cover bolts and torque # 5 bolts to 27-48 Nm (20-35 lb. ft.). and # 4 bolts to 18-36 Nm (13-26 lb. ft.). Refer to figure 2
8. Install serpentine belt idler pulley.
9. Install crankshaft balancer and torque retaining bolt to 103 Nm (76 lb. ft.).
