Regal V6-191 3.1L (1991)
Crankshaft Position Sensor: Service and Repair
Typical DIS Crankshaft Sensor
REMOVE OR DISCONNECT:
1.
Negative battery cable.
2.
Electrical connector from the crankshaft sensor.
3.
Sensor hold-down bolt.
4.
Sensor from engine.
5.
Inspect the crankshaft sensor o-ring for cracks, wear or leakage. Before installing new sensor, lubricate the new o-ring with engine oil.
INSTALL OR CONNECT:
1.
New sensor into the hole in the engine block.
2.
Tighten the sensor hold-down bolt and torque to 10 N-m (88 in. lbs).
3.
Crankshaft sensor electrical connection.
4.
Negative battery cable.
5.
Before starting engine perform IDLE LEARN PROCEDURE. Refer to ADJUSTMENT PROCEDURES/IDLE LEARN PROCEDURE.