Regal V6-191 3.1L (1991)
3.
Screw to trim panel, Coupe only.
4.
Bracket screw to door by aligning bracket on housing to hole in sheet metal and drive screw through switch cutout in housing, Sedan only.
5.
Window regulator, if removed
6.
Power window and door switch assembly, if removed. Refer to "Power Window and Door Switch Assembly" in this section.
7.
Retractor cover
SEDAN REAR DOORS
Figure 4
REMOVE OR DISCONNECT
1.
Screws from pull handle bezel
2.
Inside handle bezel
3.
Power window and door switch assembly, if present. Refer to "Power Window and Door Switch Assembly, if present. Refer to "Power Window
and Door Switch Assembly Front Door" in this section.
4.
Bracket screw to door
^
Removable through switch cutout in housing
5.
Window regulator handle, if present
6.
Lamp from armrest cutout, if present
7.
Door trim panel, using J 24595-C to disengage fasteners on trim panel from holes in door inner panel
INSTALL OR CONNECT
1.
Wire harness, if present, through opening in trim panel and armrest cutout.