Regal V6-191 3.1L VIN M SFI (1995)
10.
Install bracket to body frame. Tighten bolt to 25 N.m (18 lb. ft.).
11.
Install NEW brake hose and NEW washer to caliper (routing should be the same as in Figure 2). Tighten fitting to 44 N.m (32 lb. ft.).
12.
Install NEW brake hose to pipe. Tighten fitting to 15 N.m (11 lb. ft.).
13.
Bleed brake hydraulic system following the applicable Service Manual procedures, Section 5, Brakes.
14.
Install wheel assembly.
15.
Repeat process on other side IF REQUIRED.
16.
Install Campaign Identification Label.
