Regal V6-191 3.1L VIN M SFI (1995)
2.
Inspect both (Right & Left) rear brake hoses for proper position (see Figure 1 and Figure 2).
3.
If hose is properly positioned (as shown in Figure 2), proceed to Step 16. If hose is incorrectly positioned (as shown in Figure 1), proceed to Step
#4.
BRAKE HOSE REPLACEMENT
4.
Remove rear wheel assembly.
5.
Disconnect brake pipe from brake hose.
6.
Remove brake from body frame.
7.
Remove brake hose from caliper (washer NOT to be reused).
8.
Remove retainer from bracket and remove brake hose.
9.
Install NEW brake hose to bracket with retainer.
10.
Install bracket to body frame. Tighten bolt to 25 N.m (18 lb. ft.).
11.
Install NEW brake hose and NEW washer to caliper (routing should be the same as in Figure 2). Tighten fitting to 44 N.m (32 lb. ft.).
12.
Install NEW brake hose to pipe. Tighten fitting to 15 N.m (11 lb. ft.).
13.
Bleed brake hydraulic system following the applicable service manual procedures, Section 5, Brakes.
14.
Install wheel assembly.
15.
Repeat process on other side IF REQUIRED.
16.
Lower vehicle and install Campaign Identification Label.
