Regal V6-191 3.1L VIN M SFI (1995)
Wheel Speed Sensor: Service and Repair
Wheel Sensor
Front
Fig. 802 Front Wheel Speed Sensor Removal.
1. Raise and support vehicle.
2. Disconnect wheel sensor electrical connector, Fig. 802.
3. Remove sensor attaching bolt, then the sensor from the mounting bracket.
4. Reverse procedure to install, noting the following:
a. Torque sensor bolt to 52 ft. lbs.
Rear
The rear speed sensors and rings on these models are an integral part of the hub and bearing assembly. If speed sensors or rings are defective, the
entire assembly must be replaced as a unit. Refer to Transmission and Drivetrain/Drive Axles, Bearings and Joints/Wheel Hub. See:
Transmission and Drivetrain/Drive Axles, Bearings and Joints
