Regal V6-191 3.1L VIN M SFI (1995)
Important:
-
Use a soap solution in order to lubricate the strut mount insulator bushing for ease of installation.
-
If necessary, install the J 35668 after partially installing the bushing and position the strut as required in order to assist in bushing installation.
8. Install the strut mount insulator (1).
9. Use a No. 50 Torx(R) bit (1) and use the J 35669 in order to install the strut shaft nut.
Tighten
-
Tighten the strut piston shaft nut to 80 N.m (59 ft. lbs.).
10. Install the strut mount cover (1) and nuts (3). Align the scribe marks.
Tighten
-
Tighten the cover plate nuts (3) to 33 N.m (24 ft. lbs.).
