Regal V6-191 3.1L VIN M SFI (1995)
force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
^
Do not use any type of grease to retain parts during assembly of this unit. Greases other than the recommended assembly lube will change
transaxle fluid characteristics and cause undesirable shift conditions and/or filter clogging. It is recommended that TRANSJEL (tm) J 36850 or
equivalent be used during assembly.
1. Position bracket to transaxle.
2. Hand start transaxle mount transaxle side bracket bolts/screws.
3. Bolts/screws.
TIGHTEN
^
Bolts/screws to 95 Nm (70 ft. lbs.) starting with forward lower bolt/screw and working clockwise.
4. Remove support from transaxle.
5. Transaxle mount transaxle side bracket to transaxle mount nuts.
TIGHTEN
^
Nuts to 47 Nm (35 ft. lbs.).
6. Left front bumper fascia splash shield.
7. Left front tire and wheel.
8. Lower vehicle.
