Regal V6-231 3.8L Turbo VIN 7 FI (1986)
FIGURE 1 - VALVE BODY
5.
Inspect the casting and fluid passages for foreign materials that may have accumulated in pockets. Remove the foreign material with a small
screwdriver or an awl. (Refer to Figure 1).
6.
As necessary, repeat the washing and drying procedures as described in Steps #3 and #4 until all foreign materials are removed.
FIGURE 2 - VALVE TRAIN SPRING PIN AND SLEEVE
7.
Select a valve train and while applying a slight pressure with your finger against spring force in the valve train, remove the coiled spring pin,
sleeve or slip that retains the valve train. (Refer to Figure 2).
FIGURE 3 - REMOVE VALVE FROM VALVE BODY
8.
Slowly release pressure on the valve train and remove it from the valve body. A small flat blade screwdriver may be used to remove the bushing
from the bore. (Refer to Figure 3).
