Regal V6-231 3.8L Turbo VIN 8 4-bbl (1983)
output shaft.
NOTICE:
The OI and OU model THM 200C transmissions already have the press fit rear internal gear and output shaft and do not require
replacement on these models. Reduce end play only as indicated in Step #2.
2.
Upon reassembly of the transmission, reduce the rear end play to .10mm - .38 mm (.004 - .015 inches) by using a thicker selective washer, if
required. If the 2-1 coastdown clunk is still to harsh after performing these above repairs check the rear differential back lash and correct if
necessary.
NOTICE:
Do not let rear end play get lower than .004 inches. Transmission damage may result.
Refer to the appropriate service manual for proper procedures not stated above..
