Regal V6-231 3.8L Turbo VIN 9 FI (1984)
FIGURE 2
indicator tab part number 1264952 must be ordered from WDDGM and installed (Figure 2).
5.
Ignition on, engine stopped.
6.
Facing the front of the engine manually rotate crankshaft clockwise to get #1 cylinder on TDC compression stroke. With timing marks lined up
monitor volt-ohm meter, slowly continue to rotate the crankshaft until the reading on the volt-ohm meter goes from a high of (5 to 7) volts to a
lower voltage. The TDC mark on the crankshaft should be at 25~ past TDC when voltage drops (Figure 2). If voltage drops before or after the 25~
mark past TDC position the sensor must be retimed. If the voltage does not drop until the crankshaft is rotated on around another 360~ (1
