Regal V6-231 3.8L Turbo VIN 9 FI (1984)
FIGURE 3
3.
If these items are okay, mark the short end of a 1/16" allen wrench as illustrated in Figure 2 (shown below). Using the allen wrench as a gauge,
insert the small end into the forward clutch feed orifice hole (See Figure #3) and make sure the allen wrench goes into the orifice hole (without any
drag) until the mark on the wrench is flush with the ground diameter. (Refer to Figure #3).
If it is necessary to replace any of the parts listed in this bulletin refer to chart below:
Housing Assembly
Forward Clutch
Turbine Shaft
Model
Forward Clutch
Piston Seals
Seals (Teflon (R)
All Models
BH,OU
8638944
8628924
8628090