Regal V6-231 3.8L VIN L SFI (1990)
STOPLAMP SWITCH ADJUSTMENT
(Figures 1 through 5 may be helpful in performing this procedure).
1.
Depress brake pedal as far as possible and hold.
Figure 4 Brake Switch Release Tool
Figure 5 Releasing Brake Stoplamp Switch
2.
Using a stiff wire and a hooked end (see Figures 4 and 5), gently pull switch set lever forward (toward front of vehicle), and listen for an
audible click indicating release of automatic adjustor.
NOTICE: If no click is heard, release brake pedal and repeat above procedure.
3.
After release of automatic adjustor, pull brake pedal all the way rearward. Listen for switch to ratchet into set position (setting the
stoplamp switch). At least three (3) clicks of the ratchet must be heard.
