Regal V6-231 3.8L VIN L SFI (1990)
Figure 2
CORRECTION:
1990 Vehicles Replace existing power steering inlet (pressure) hose and pipe assembly, pump flow control valve and alter heat shield following
applicable Service Manual procedures, Bulletin 91-3-13 (Corp. # 133205) and noted in Figures 1 and 2.
Parts Required
P/N 26028655
Inlet Hose and Pipe Asm.
P/N 7841852
Pump Flow Control Valve
1991 Vehicles Replace existing power steering inlet (pressure) hose and pipe assembly and alter heat shield following applicable Service Manual
procedures, Bulletin 91-3-13 and noted in Figures 1 and 2.
Parts Required
P/N 26028655 Inlet Hose and Pipe Asm.
Parts are currently available from GMSPO.
WARRANTY INFORMATION:
Labor Operation Number:
T1719
Labor Time:
1990
1.3 Hours
1991
1.0 Hours
Hose Installation sequence
1.
Install hose and hand tighten fitting at pump.
2.
Position to achieve light touch condition between foam sleeve and oil filter adapter (see point "A" on figure).
3.
Torque pump hose fitting to 27 N-m (20 ft.lbs.) maintaining hose position noted in step 2.
4.
Hand tighten fitting at power steering gear.
5.
Install clamp on steering gear.
6.
Torque steering gear hose fitting to 27 N-m (20 ft.lbs.)