Regal V6-231 3.8L VIN L SFI (1990)
Wheel Bearing: Service and Repair
Hub & Bearing Assembly
FRONT WHEEL BEARINGS AND/OR HUB
Fig. 1 Removing Hub & Bearing Assembly
1.
Remove wheel cover, then loosen drive axle shaft nut and washer one turn. Do not remove nut at this time. Failure to follow proper removal
sequence may cause bearing damage.
2.
Raise and support vehicle, then remove wheel and tire assembly.
3.
Remove brake caliper and bracket assembly, then the brake rotor, Fig. 1.
4.
Remove drive axle shaft nut and washer.
5.
Loosen hub and bearing assembly to knuckle attaching bolts.
6.
Using front hub spindle remover tool No. J-28733-A or equivalent, push axle splines back out of hub and bearing assembly.
7.
Remove hub and bearing assembly to knuckle attaching bolts.
8.
On models with anti-lock brakes (ABS), remove ABS sensor mounting bolt and position sensor aside.
9.
On all models, remove hub and bearing assembly. Protect axle boots from damage during handling.
10.
Reverse procedure to install, Torquing all bolts to specifications.
