buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

A/T - Harsh 3-2 Downshifts > < 9174T609A
Page 1
background image

Shift Modulator: All Technical Service Bulletins
A/T- Shudder In 1st/Reverse When Pedal is Released

Bulletin: 91-74T60-9A

Date: July '92

Ref. No.: 91-304-74T60

Corp. Ref. No.: 077154R

SUBJECT:
SHUDDER IN 1ST/REVERSE AT 0-10 MPH DURING LIFT-FOOT MANEUVER (NEW ENGINE VACUUM MANIFOLD ASM)

MODELS AFFECTED:
1990-91 REGAL WITH 3800 V6 ENGINE 
1991 PARK AVENUE9 RIVIERA AND REATTA MODELS

THIS BULLETIN HAS BEEN REVISED TO CORRECT SERVICE PARTS INFORMATION. PLEASE DISCARD BULLETIN # 91-74T60-9.

BULLETIN COVERS:

A vehicle equipped with a 3800 EV6 engine and a HYDRA-MATIC 4T60-E or HYDRA-MATIC 4T60 transaxle may experience lift-foot shudder. This
shudder occurs when the driver accelerates from 0 MPH at 112 to full throttle and then quickly lifts their foot from the throttle (under 10 MPH). This is
caused by the vacuum modulator responding too quickly to engine vacuum. A new vacuum manifold block assembly with an orifice will slow vacuum
response to the transaxle approximately 1/10 of a second. This will allow the transaxle to have sufficient line pressure to hold the bands and clutches
during lift-foot maneuvers.

SERVICE PROCEDURE:

To repair the lift-foot shudder condition, replace the existing engine vacuum manifold block assembly (located on the intake manifold) with the new
vacuum manifold block assembly which incorporates a vacuum orifice. Mark or tag the vacuum hoses so the hoses do not get switched. In the unlikely
event that the new vacuum manifold block assembly does not eliminate the lift-foot shudder, refer to the diagnosis section of the service manual.

IMPORTANT:
Do not try to modify the existing vacuum manifold block with an orifice. Without the orifice being the correct size or made from the correct material, the
orifice will eventually clog and cause a harsh or soft shift concern.

Do not install this new vacuum manifold block assembly with an orifice on a non-3800 EV6 engine that has an Exhaust Gas Recirculating (EGR) valve.
The orifice could become plugged with debris from exhaust gases and cause a harsh or soft shift concern.

SERVICE PARTS INFORMATION:

Parts are currently available from GMSPO.

A/T - Harsh 3-2 Downshifts > < 9174T609A