Regal V6-231 3.8L VIN L SFI (1990)
COUPE AND SEDAN FRONT DOORS
TOOL REQUIRED:
J24595-C Door Trim and Garnish Clip Remover
Figure 3
REMOVE OR DISCONNECT
1.
Escutcheon cover
2.
Screws and safety belt from shoulder belt escutcheon
3.
Pull handle screws
4.
Retractor cover
5.
Power window switch assembly, if present. Refer to "Power Window and Door Switch assembly" in this section.
6.
Bracket screw to door, Sedan only
^
Removable through switch cutout in housing
7.
Window regulator, if present
8.
Screw from trim panel, Coupe only
9.
Door trim panel using J 24595-C to disengage fasteners on trim panel from holes in door inner panel.
INSTALL OR CONNECT
1.
Wire harness, if present, through openings in trim panel
2.
Trim panel to door by aligning fasteners on trim panel to holes in door inner panel and pressing trim panel to door until fasteners are fully
engaged.
