Regal V6-231 3.8L VIN L SFI (1990)
3.
Using a 1/4" drill bit, drill out the ends of all 3 motor to regulator attaching rivets from the motor side of the assembly (See Figure 1).
4.
Remove the motor from the regulator and the remaining portions of the rivets.
5.
Position new motor to the regulator backplate and with the aid of a helper, install motor with 1 rivet (bottom location, Figure 1) by collapsing or
crushing end of rivet (P/N 9441949) with a ball peen type hammer as shown in Figure 2.
Parts are currently available from GMSPO.
