Regal V6-231 3.8L VIN L SFI (1990)
2.
Using bedding and glazing compound run a 5 mm bead around the perimeter of the mirror mounting surface as shown in Figure 6.
3.
Before the molding is re-installed, coat the outer belt retaining flange with silicone lubricant so that the molding can be removed at a later
date.
VIII. Windnoise under the outer door beltline reveal molding.
1.
Remove the outer door beltline molding per Section 10 of the Service Manual.
2.
With the molding removed, apply a bead of silicone along the full length of the molding in the molding cavity as shown in Figure 7.
Labor Operation Table
IX.
Road noise caused by inner belt seal gap to glass. 1988 to 1993 Sedans and 1988 to 1995 Coupes.
