Regal V6-3.8L SC VIN 1 (1998)
26. Wait five seconds.
27. Repeat the previous five steps until air bubbles are no longer visible in the bleeder hose.
28. Bleed the traction control module.
28.1. Attach a clear plastic bleeder hose to the right side bleeder valve on the traction control module.
28.2. Submerge the opposite hose end in a clean container partially filled with the clean brake fluid.
28.3. Depress the brake pedal with moderate force.
28.4. Slowly open the bleeder valve and allow the fluid to flow.
28.5. Close the valve and release the brake pedal.
28.6. Wait five seconds.
28.7. Repeat the previous six steps until air bubbles are no longer visible in the bleeder hose.
28.8. Relocate the bleeder hose to the left side of the traction control module bleeder valve.
28.9. Submerge the opposite hose end in a clean container partially filled with the clean brake fluid.
28.10 Depress the brake pedal with moderate force.
28.11. Slowly open the bleeder valve and allow the fluid to flow.
28.12 Close the valve and release the brake pedal.
28.13 Wait five seconds.
Repeat the previous five steps until air bubbles are no longer visible in the bleeder hose.
29. Remove the brake fluid reservoir cover.
30. Inspect the brake fluid level in the reservoir. Fill to the correct level if necessary.
31. Install the brake fluid reservoir cover.
32. Turn the ignition switch to the RUN position, then turn off the engine. Apply the brake pedal with moderate force and hold the pedal. Note the
pedal travel and feel.
33. If the pedal feels firm and constant and pedal travel is not excessive, start the engine. With the engine running, recheck the pedal travel.
34. If the pedal feel is still firm and constant and pedal travel is not excessive, perform a vehicle road test. Make several normal (non-ABS) stops from
a moderate speed in order to ensure proper brake system function.
35. If pedal feel is soft or has excessive travel either initially or after engine start, use the following procedure:
35.1. Using the Scan Tool, release then apply each motor 2-3 times and cycle each solenoid 5-10 times.
35.2. Apply the front and the rear motors in order to ensure that the pistons are in the upmost position. Do not drive the vehicle.
35.3. If a Scan Tool is not available, remove your foot from the brake pedal, then start the engine. Allow the engine to run for at least ten seconds
