Regal V6-3.8L SC VIN 1 (1998)
Brake Caliper: Technical Service Bulletins
Brake Calipers - Revised Fastener Requirements
File In Section: 05 - Brakes
Bulletin No.: 01-05-23-006A
Date: June, 2001
SERVICE MANUAL UPDATE
Subject:
Revised Fastener Requirements for Front and Rear Brake Caliper Bracket Replacement
Models:
1997-2001 Buick Century, Regal
1997-2001 Buick Regal (Export China)
1997-2001 Chevrolet Trans Sport (Export China), Venture
2000-2001 Chevrolet Impala, Monte Carlo
1998-2001 Oldsmobile Intrigue
1997-1998 Pontiac Trans Sport
1997-2001 Pontiac Grand Prix
1999-2001 Pontiac Montana
This bulletin is being revised to update the model information. Please discard Corporate Bulletin Number 01-05-23-006 (Section 05 - Brakes).
This bulletin is being issued to revise the fastener requirements for the front and rear brake caliper bracket replacement procedures in the Disc-Brake
sub-section of Brakes in the appropriate Service Manual. Please use the following to replace the existing information in the Service Manual.
This information has been updated within SI2000. If you are using a paper version of this Service Manual, please mark a reference to this bulletin on the
affected page in the Disc-Brake sub-section of the Service Manual.
Front Brake Caliper Bracket Replacement
(All Above Listed Vehicles)
1.
Remove the caliper from the mounting bracket and support the caliper with heavy mechanics wire or equivalent. It is not necessary to disconnect
the hydraulic brake flexible hose from the caliper.
2.
Remove the front brake pads.
3.
Remove the caliper bracket bolts (2).
4.
Remove the caliper bracket (1).
