Regal V6-3.8L SC VIN 1 (1998)
3. With either of the modulators positioned upside down, and the gears facing your, rotate each ABS brake modulator gear counterclockwise until
movement stops.
Rotating the modulator gears will cause the following conditions:
^
The pistons on the ABS brake modulator will be positioned very close to the top of the modulator bore.
^
The brake bleeding procedure is simplified.
IMPORTANT: Use care when handling the motor pack. Replace the motor pack if the motor pack is dropped or damaged during handling.
4. Position the motor pack onto the modulator, aligning the three motor pack gears with the modulator gears.
5. Install four motor pack to modulator Torx head screws.
^
Tighten the Torx head screws to 4.5 Nm (40 ft lbs).
6. Install the gear cover onto the modulator with Torx head screws.
^
Tighten the Torx head screws to 4 Nm (45 inch lbs).
7. Install the modulator-master cylinder assembly. Refer to Brake Modulator Replacement.
