Regal V6-3.8L SC VIN 1 (1998)
9. Remove the fuel filler pipe attaching screws (3) from the fuel filler pipe access panel.
10. Remove the fuel filler pipe.
Installation Procedure
1. Install the fuel filler pipe.
2. Install the fuel filler pipe attaching screws (3) to the fuel filler pipe access panel.
Tighten
The fuel filler pipe attaching screws to 10 Nm (8 lb. ft.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the fuel filler pipe attaching screw (1) to the under body.
Tighten
The fuel filler pipe attaching screw to 10 Nm (8 lb. ft.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Connect the vapor recirculation line at the fuel filler pipe.
5. Install the fuel filler hose.
6. Install the fuel filler hose clamp at the fuel tank.
7. Install the fuel filler hose clamp at the fuel filler pipe.
8. Inspect and make sure filler hose (4) is fully seated on fuel tank port, and fuel filler pipe (2).
9. Make sure clamp (1) is properly located on tank port between the feed (5) and tank (3).
Tighten
Tighten the fuel tank filler hose clamps to 2.5 Nm (22 lb. in.).
Notice: Refer to Fastener Notice in Service Precautions.
10. Lower the vehicle.
11. Inspect for leaks.
11.1. Inspect turn the ignition switch to the ON position for two seconds.
11.2. Turn the ignition switch to the OFF position for ten seconds.
