Regal V6-3.8L SC VIN 1 (1998)
^
The ignition is ON.
^
The Vehicle Interface Module cable connection at the DLC is secure.
2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user 5 instructions.
3. If the PCM fails to program, proceed as follows:
^
Ensure that all PCM connections are OK.
^
Check the Techline equipment for the latest software version.
^
Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. You must program the replacement PCM.
Functional Check
1. Perform the On-Board Diagnostic System Check.
2. Start the engine and the engine run for one minute.
3. Use the scan tool in order to scan for the DTCs.
