Regal V6-3.8L SC VIN 1 (1998)
Seat Belt Retractor: Service and Repair
Driver Seat Retractor Side Belt Replacement
Removal Procedure
Description
1. Open the seat belt guide loop cover.
2. Remove the guide loop nut.
3. Remove the guide loop from the guide adjuster bracket.
4. Remove the center pillar lower trim. Refer to Center Pillar Lower Trim Panel in Doors.
5. Remove the intermediate guide bolts.
6. Remove the anchor plate nut from the seat stud.
7. Remove the anchor plate from the seat stud.
8. Remove the retractor side belt bolt.
9. Remove the retractor side belt from the center pillar.
Installation Procedure
Description
1. Install the belt retractor into the T-slot in the center pillar.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the retractor side belt bolt.
Tighten
Tighten the retractor side belt bolt to 42 N.m (31 lb. ft).
3. Install the intermediate guide bolts.
Tighten
Tighten the intermediate guide bolts to 10 N.m (89 lb. in).
4. Position the anchor plate to the seat stud.
5. Install the anchor plate nut to the seat stud.
Tighten
