Regal V6-3.8L SC VIN 1 (1998)
Throttle Position Sensor: Testing and Inspection
A broken or loose TP sensor may cause intermittent bursts of fuel from an injector and unstable idle because the PCM thinks the throttle is moving. A
hard failure in the TP sensor 5 volts reference or signal circuits should set either a DTC P0122 or DTC P0123. A hard failure with the TP sensor
ground circuit may set DTCs P0123 and P0117. Once a DTC is set, the PCM will use an artificial default value based on engine RPM and mass air
flow for throttle position and some vehicle performance will return. A high idle may result when either DTC P0122 or DTC P0123 is set.
The PCM can detect intermittent TP sensor faults. DTC P1121 or DTC P1122 will set if an intermittent high or low circuit failure is being detected.
The PCM can also detect a shifted TP sensor. The PCM monitors throttle position and compares the actual TP sensor reading to a predicted TP value
calculated from engine speed. If the PCM detects an out of range condition, DTC P0121 will be set. For DTC diagnosis refer to System Diagnosis /
Diagnostic Tables / Diagnostic Trouble Code Tables. See: Powertrain Management/Computers and Control Systems/Testing and Inspection
