Regal V6-3.8L SC VIN 1 (1998)
Wheels: Service and Repair
Aluminum Wheel Hub Cap Replacement
REMOVAL PROCEDURE
1. Remove the tire and wheel assembly. Refer to WHEEL REMOVAL.
2. Place a squared off block of wood approximately 50 mm (2 in) diameter against the back surface of the cap.
3. Use a hammer to strike the block of wood to remove the cap.
INSTALLATION PROCEDURE
NOTICE: Failure to hit the cap squarely without the load distributed evenly could result in permanent damage to the cap.
1. Place the cap into position at the wheel opening.
2. Place a block of wood at least 76 mm (3 in) diameter against the cap face.
3. Use a hammer to strike the block of wood to install the cap.
4. Install the tire and wheel assembly. Refer to WHEEL INSTALLATION.
