Regal V6-3.8L SC VIN 1 (1998)
12. Remove the transaxle oil cooler pipe and hose from the vehicle. Refer to Automatic Transmission Oil Cooler Hose Replacement.
INSTALLATION PROCEDURE
1. Install the transaxle oil cooler pipe and hose to the vehicle. Refer to Automatic Transmission Oil Cooler Hose Replacement.
2. Install the transaxle oil cooler pipe clip.
3. Install the transaxle oil cooler pipe clip bolt.
^
Tighten the transaxle oil cooler pipe clip bolt to 10 Nm (89 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
IMPORTANT:
^
Do not reuse any of the existing retaining rings that were removed from the existing quick connect fittings. All retaining rings being installed
must be new.
^
Ensure the following procedures are performed when installing the new retaining rings onto the fittings. Install a new retaining ring (E-clip)
into the quick connect fitting using the following procedure:
