Regal V6-3.8L SC VIN 1 (1998)
A/T Mount Bracket Replacement
REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the left front tire and wheel assembly.
Refer to Tire and Wheel Removal and Installation.
3. Remove the left engine splash shield. Refer to Splash Shield Replacement-Engine in Body and Frame.
4. Use floor stands to support the transaxle.
5. Remove the transaxle bracket to transaxle mount upper nuts.
6. Remove the transaxle bracket to transaxle bolts.
7. Remove the transaxle bracket.
INSTALLATION PROCEDURE
1. Position the transaxle bracket to the transaxle.
2. Hand start the transaxle mount bracket to transaxle bolts.
3. Install the transaxle bracket bolts.
^
Start with the forward lower bolt and work clockwise to tighten the transaxle bracket bolts to 95 Nm (70 ft. lbs.).
