Regal V6-3.8L VIN K (1997)
Wheel Speed Sensor: Service and Repair
Left Front Wheel Speed Sensor Jumper Harness
Left Front Wheel Speed Sensor Jumper Harness
REMOVE OR DISCONNECT
1. Raise and support vehicle on suitable hoist, as indicated.
2. Connector from wheel speed sensor.
3. Harness from retaining clips.
4. Retainer at inner fender.
5. Lower vehicle.
6. Transmission cable retainer and various harnesses from restraints at left strut tower to access jumper harness connector.
7. Upper jumper harness connector.
8. Remove jumper harness.
INSTALL OR CONNECT
1. Route new jumper harness through inner fender pass thru.
2. Upper jumper harness connector.
3. Transmission cable retainer and various harness to restraints that may have been disconnected to access jumper harness.
4. Raise vehicle.
5. Seat harness into position in the inner fender.
6. Retainer.
7. Harness to sensor.
8. Harness to retaining clip.
